Supra Sport Roof L6-2997cc 3.0L DOHC MFI (1998)
Hood Sensor/Switch (For Alarm): Diagnostic Aids
Disconnection and Connection of Bolt Type Connectors
Disconnection And Connection Of Bolt Type Connectors
For engine control module in this vehicle, connectors are used which require a bolt built into the connector to be screwed down to securely connect the
connector.
1. Disconnect the connector
After completely loosening the bolt, the two parts of the connector can be separated.
NOTE: Do not pull the wire harness when disconnecting the connector.
2. Connect the connector
NOTE: Before connecting the connector, always check that the terminals are not bent or damaged.
(a) Match the guide section of the male connector correctly with the female connector, then press them together.
(b) Tighten the bolt.
Make sure the connectors are completely connected, by tightening the bolt until there is a clearance of less than 1 mm (0.04 in.) between the
bottom of male connector and the end of female connector.
Disconnection of Male and Female Connectors
