toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Radiator|Removal and Installation|Page 2116 > < Radiator|Removal and Installation|Page 2114
Page 1
background image

Radiator: Service and Repair
Disassembly and Assembly

DISASSEMBLY 

1. REMOVE CUSHIONS FROM RADIATOR

2. ASSEMBLE SPECIAL SERVICE TOOL (SST)

SST 09230 - 01010
a. Install the claw to the overhaul handle, inserting it in the hole in part "A" as shown in the installation.
b. While gripping the handle, adjust the stopper bolt so that dimension "B" shown in the diagram is 0.2 - 0.5 mm (0.008 - 0.020 inch).

NOTICE:  If this adjustment is not done, the claw may be damaged.

3. UNCAULK LOCK PLATES

Using SST to release the caulking, squeeze the handle until stopped by the stopper bolt.
SST 09230 - 01010

4. REMOVE TANKS AND O-RINGS

a. Lightly tap the radiator hose inlet (or outlet) with a soft faced hammer and remove the tank.
b. Remove the O-ring.

5. A/T: REMOVE OIL COOLER FROM LOWER TANK

Radiator|Removal and Installation|Page 2116 > < Radiator|Removal and Installation|Page 2114