Supra Sport Roof L6-2997cc 3.0L DOHC MFI (1998)
a. Remove the 3 bolts, clamp, end cover, gasket and plunger.
b. Using vernier calipers, measure the contact plate for depth of wear.
Maximum wear: 0.9 mm (0.035 in.)
If the depth of wear is greater than the maximum, replace the contact plate.
c. Remove the terminal kit parts.
1. Using SST, loosen the terminal nuts.
SST 09810-38140
2. Terminal C:
Remove the terminal nut, wave washer, terminal insulator (outside), O-ring, terminal bolt, contact plate and terminal insulator (inside).
3. Terminal 30:
Remove the terminal nut, wave washer, terminal insulator (outside), packing, O-ring, terminal bolt, contact plate, terminal insulator (inside)
and insulation paper.
d. Temporarily install these new terminal 30 kit parts;
1. Insulation paper
2. Terminal insulator (inside)
3. Contact plate
4. Terminal bolt
5. O-ring
6. Packing and terminal insulator (outside) Install the packing to the terminal insulator, and install them.
HINT: Match the protrusion of the insulator with the indentation of the housing.
