toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Power Steering Pump|Removal and Installation|Page 6497 > < Power Steering Pump|Removal and Installation|Page 6495
Page 3
background image

HINT:  Make sure that the stopper of the tube is touching the power steering vane pump assembly as shown, before tightening the union bolt.

Torque: 49 Nm (36 ft lbs.).

3. Connect the return tube.

4. Install drive belt. 

Loosen the drive belt tension by turning the drive belt tensioner clockwise, and install the drive belt.

5. Install battery.

a. Install the battery carrier and battery.
b. Install the battery cover.
c. Install the battery clamp with bolt and nut.
d. Connect the two terminals.

6. Install engine under cover. 

Install the ten screws.

7. Bleed power steering system.

Power Steering Pump|Removal and Installation|Page 6497 > < Power Steering Pump|Removal and Installation|Page 6495