Supra Sport Roof L6-2997cc 3.0L DOHC MFI (1998)
HINT: If the hole is clogged, the pressure inside the boot will change after it is assembled and the steering wheel turned.
b. Install the boot.
NOTICE: Be careful not to damage or twist the boot.
c. Install the clamp and clip to the boot.
HINT: When the rack guide spring cap is toward you, install the clip and clamp in the positions shown in the illustration.
17. Install right and left hand tie rod ends and lock nuts.
a. Screw the lock nut and tie rod end onto the rack end until the matchmarks are aligned.
b. After adjusting the toe-in, torque the nut.
Torque: 56 Nm (41 ft. lbs.).
18. Install two turn pressure tubes.
a. Install the two union seats.
b. Using SST 09633-00020 or equivalent, install the tube.
Torque: 24 Nm (18 ft. lbs.).
HINT:
-
Use a torque wrench with a fulcrum length of 300 mm (11.81 inch).
-
This torque value is effective in case that the SST is parallel to a torque wrench.
c. Torque the union bolt over two new gaskets.
Torque: 34 Nm (25 ft. lbs.)
