Supra Sport Roof L6-2997cc 3.0L DOHC MFI (1998)
Transmission Speed Sensor: Service and Repair
O/D Direct Clutch Speed Sensor
O/D DIRECT CLUTCH SPEED SENSOR
ON-VEHICLE REPAIR
1. DISCONNECT O/D DIRECT CLUTCH SPEED SENSOR CONNECTOR
2. REMOVE O/D DIRECT CLUTCH SPEED SENSOR
a. Remove the bolt and O/D direct clutch speed sensor.
b. Remove the O-ring.
3. INSTALL O/D DIRECT CLUTCH SPEED SENSOR
a. Coat a new O-ring with ATF and install it to the O/D direct clutch speed sensor.
b. Install the O/D direct clutch speed sensor to the transmission case and torque the bolt.
Torque: 5.4 Nm (55 kgf-cm, 48 inch lbs.)
4. CONNECT O/D DIRECT CLUTCH SPEED SENSOR CONNECTOR
SENSOR ROTOR
ON-VEHICLE REPAIR
1. RAISE VEHICLE AND POSITION PAN TO CATCH ANY FLUID THAT MAY DRIP
2. REMOVE PROPELLER SHAFT
3. REMOVE VEHICLE SPEED SENSOR
4. JACK UP TRANSMISSION SLIGHTLY
Securely support the transmission on a transmission jack.
Lift the transmission slightly from the rear support member.
