toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Transmission Temperature Sensor/Switch, A/T > < N.1 and No.2 Speed Sensor|Page 5021
Page 3
background image

10. INSTALL EXTENSION HOUSING

a. Apply seal packing to the extension housing.

Seal packing: Part No. 08826-00090, THREE BOND 1281 or equivalent

b. Install the 6 bolts.

HINT:
^

Coat the thread of the all bolts with sealant.

Sealant: Part No. 08833-00080, THREE BOND 1344, LOCTITE 242 or equivalent 

^

The 2 lower bolts are shorter.

Torque: 34 Nm (345 kgf-cm, 25 ft. lbs.)

11. INSTALL TRANSMISSION MOUNTING BRACKET 

Install    the bracket and 4 bolts to the transmission.

Torque: 25 Nm (250 kgf-cm, 18 ft. lbs.)

12. INSTALL REAR SUPPORT MEMBER

a. Install the support member and 4 bolts.

Torque: 25 Nm (250 kgf-cm, 18 ft. lbs.)

b. Install the 4 nuts.

Torque: 13 Nm (130 kgf-cm, 9 ft. lbs.)

13. REMOVE JACK
14. INSTALL VEHICLE SPEED SENSOR
15. INSTALL PROPELLER SHAFT
16. FILL ATF AND CHECK FLUID LEVEL

Transmission Temperature Sensor/Switch, A/T > < N.1 and No.2 Speed Sensor|Page 5021