Supra Sport Roof L6-2997cc 3.0L DOHC MFI (1998)
(1) Place matchmarks on the flanges.
(2) Remove the 4 bolts, washers and nuts.
(b) Remove the center support bearing from intermediate shaft.
(1) Using a chisel and hammer, loosen the staked part of the nut.
(2) Using SST to hold the flange, remove the nut. SST 09930-00021
(3) Remove the washer.
(4) Place matchmarks on the flange and intermediate shaft.
(5) Using a brass and hammer, remove the flange, 2 washers and center support bearing from the intermediate shaft.
(c) Install a new center support bearing on intermediate shaft.
HINT: Install the center support bearing in the direction, as shown and install the 2 washers.
(d) Install the flange on intermediate shaft.
(1) Coat the spline of the intermediate shaft with MP grease.
(2) Place the flange on the shaft and align the match-marks.
HINT: If replacing either the center flange or intermediate shaft, reassemble them so that the front yoke of the intermediate shaft and the
rear yoke of the propeller shaft are facing in the same direction.
(3) Install the washer.