T100 Extra Cab Pickup 4WD V6-3.4L (5VZ-FE) (1997)
/Page-1333002.png)
a. Using SST 09308 - 10010 or equivalent, remove the oil seal.
b. Remove the oil slinger.
5. Remove rear bearing and bearing spacer, as follows:
a. Using SST 09556 - 22010 or equivalent, remove the rear bearing from the drive pinion.
b. Remove the bearing spacer.
6. Install the bearing spacer, rear bearing and the oil slinger, as follows:
a. Install a new bearing spacer.
b. Install the rear bearing.
c. Install the oil slinger.
7. Install the oil seal, as follows:
a. Using SST 09554 - 30011 or equivalent and a hammer, install a new oil seal.
Oil seal drive in depth: 1.5 mm (0.059 inch).
b. Apply Multipurpose (MP) grease to the oil seal lip.
8. Install companion flange, as follows:
a. Using SST 09950 - 30010 or equivalent, install the companion flange on the drive pinion.
b. Apply light coat of hypoid gear oil on threads of a new companion flange nut.
