T100 Extra Cab Pickup 4WD V6-3.4L (5VZ-FE) (1997)
/Page-2112001.png)
Wiper Motor: Testing and Inspection
INSPECT MOTOR OPERATION
Low Speed
Connect the positive (+) lead from the battery to terminal 3 and the negative (-) lead from the battery to the motor body, check that the motor operates
at low speed.
If operation is not as specified, replace the motor.
High Speed
Connect the positive (+) lead from the battery to terminal 2 and the negative (-) lead from the battery to the motor body, check that the motor operates
at high speed.
If operation is not as specified, replace the motor.
Stopping at Stop Position
1. Operate the motor at low speed and stop the motor operation anywhere except at the stop position by disconnecting positive (+) lead from terminal
3.
2. Connect terminals 3 and 5.
3. Connect the positive (+) lead from the battery to terminal 6 and the negative (-) lead from the battery to the motor body, check that the motor stops
running at the stop position after the motor operates again. If operation is not as specified, replace the motor.
