T100 Pickup 2WD L4-164.4 2693cc 2.7L DOHC (3RZ-FE) (1995)
Ignition Cable: Testing and Inspection
1. REMOVE AIR CLEANER CAP AND MASS AIR FLOW (MAF) METER ASSEMBLY.
-
Disconnect the MAF meter connector and Intake Air Temperature (IAT) sensor connector.
-
Loosen the hose clamp and disconnect the air cleaner hose from the intake air connector.
-
Remove the air cleaner cap and MAF meter assembly.
2. REMOVE INTAKE AIR CONNECTOR.
-
Disconnect these hoses from the intake air connector:
-
No.3 air hose from Idle Speed Controller (ISC) valve
-
with A/C: A/C air hose from A/C idle-up valve.
-
Remove the 2 bolts.
-
Loosen the hose clamp and disconnect the intake air connector from the throttle body.
3. WITH A/C: REMOVE A/C IDLE-UP VALVE.
-
Disconnect the A/C idle-up valve connector.
-
Disconnect the air hose from the air intake chamber.
-
Remove the bolt and A/C idle-up valve.
4. DISCONNECT HIGH-TENSION CORDS FROM SPARK PLUGS.
-
Disconnect the high - tension cords at the rubber boot.
DO NOT pull on the cords.