T100 Pickup 2WD L4-164.4 2693cc 2.7L DOHC (3RZ-FE) (1995)
Crankshaft Position Sensor (NE Signal): Service and Repair
INSTALLATION HINT: Installation is in the reverse order of removal.
1. REMOVE ENGINE UNDER COVER.
2. REMOVE ALTERNATOR.
3. REMOVE ALTERNATOR BRACKET.
-
Remove the 3 bolts and bracket.
-
Torque:
Bolt A: 74.5 Nm (55 ft lb)
Bolt B: 18 Nm (13 ft lb)
4. DISCONNECT CRANKSHAFT POSITION SENSOR CONNECTOR.
5. REMOVE CRANKSHAFT POSITION SENSOR.
-
Remove the 2 bolts and crankshaft position sensor.
-
Torque: 8.5 Nm (74 in lb)
-
Remove the O-ring.
INSTALLATION HINT:
-
Always use a new O-ring when installing the crankshaft position sensor.
-
Apply a light coat of engine oil on the O-ring.