T100 Pickup 4WD V6-180.5 2959cc 3.0L SOHC (3VZ-E) (1993)
Ignition Cable: Testing and Inspection
INSPECTION
1. Disconnect High-tension Cords from Spark Plugs at the rubber boot. DO NOT Pull On The Cords. Pulling on or bending the cords may damage
the conductor inside.
2. Disconnect High-tension Cords from Distributor Cap and Ignition Coil.
^
Using a screwdriver, lift up the lock claw and disconnect the holder from the Distributor Cap (ignition Coil).
^
Disconnect the High-tension Cord at the grommet. DO NOT pull on the cord. Pulling on or bending the cords may damage the conductor
inside. Do not wipe any of the oil from the grommet after the high-tension cord is disconnected.
3. Inspect hIgh-tension Cord resistance. Using an ohmmeter, measure the resistance.
Maximum resistance: 25 k ohms per cord
If the resistance is greater than maximum, check the terminals. If necessary, replace the High-tension Cord.
4. Reconnect High-tension Cords to Distributor Cap and Ignition Coil.