T100 Pickup 4WD V6-180.5 2959cc 3.0L SOHC (3VZ-E) (1993)
/Page-805002.png)
^
Tighten the 4 nuts holding the delivery pipes to the intake manifold.
Torque: 13 Nm (9 ft lb).
^
Install the No. 1 fuel pipe to the No. 3 bearing cap with the bolt.
2. Install No. 2 And No. 3 fuel pipes.
^
Install the No. 2 fuel pipe with 4 new gaskets and 2 union bolts.
Torque: 34 Nm (25 ft lb).
^
Install the No. 3 fuel pipe with 4 new gaskets and 2 union bolts.
Torque: 34 Nm (25 ft lb).
3. Install the engine wire with the 2 bolts. Connect the following connectors:
^
Injector connectors
^
RH ground strap
^
Engine coolant temperature. sender gauge connector
^
Engine coolant temperature. sensor connector
^
Cold start injector time switch connector
^
Knock sensor connector
4. Install air intake chamber.
^
Position a new gasket on the intake manifold.
^
Install the intake chamber with the 6 bolts and 2 nuts.
