T100 Pickup 4WD V6-180.5 2959cc 3.0L SOHC (3VZ-E) (1993)
/Page-41002.png)
7. Using an ohmmeter, measure resistance between Ignition Coil (+) and (-) terminals.
Primary Resistance (Cold): 0.3 - 0.6 ohms
8. Using an ohmmeter, measure resistance between Ignition Coil (+) and the secondary terminals.
Secondary Resistance (Cold): 9.0 - 15 k ohms
9. Check Ignition Coil for signs of carbon tracking, burned or discolored plastic, external leakage, or cracks in the housing.
10. If Ignition Coil resistance is not within specifications or physical damage is apparent, replace Ignition Coil.
Pickup Coil Connector
11. Disconnect primary wire connector at Distributor.
12. Using an ohmmeter, measure resistance between terminals G1 and G-.
G1 Pickup Coil Resistance: 125 - 200 ohms
13. Using an ohmmeter, measure resistance between terminals G2 and G-.
G2 Pickup Coil resistance: 125 - 200 ohms
14. Using an ohmmeter, measure resistance between terminals NE and G-.
NE Pickup Coil resistance: 155 - 250 ohms
15. If resistance was not within specifications, replace Distributor assembly. If no faults were found, proceed with this test.
Pick-up Coil Air Gap
