T100 Pickup 4WD V6-3.4L (5VZ-FE) (1995)
/Page-156002.png)
Maximum resistance: 25 k Ohms per cord.
-
If the resistance is greater than the maximum, check the terminals. If necessary, replace the high-tension cord.
5. RECONNECT HIGH-TENSION CORDS TO IGNITION COILS.
-
Assemble the holder and grommet.
-
Align the spline of the ignition coil with the spline of the holder, and push in the cord.
NOTICE: Check that the holder is correctly installed to the grommet and distributor cap as shown in the illustration.
-
Check that the lock claw of the holder is engaged by lightly pulling the holder.
6. RECONNECT HIGH-TENSION CORDS TO SPARK PLUGS.
