T100 Regular Cab Pickup 2WD L4-2693cc 2.7L DOHC MFI (1998)
Crankshaft Position Sensor: Service and Repair
REMOVAL
1. REMOVE ENGINE UNDER COVER
2. REMOVE GENERATOR
3. REMOVE GENERATOR BRACKET Remove the 3 bolts and bracket.
Torque:
Bolt A: 74.5 N.m (760 kgf.cm, 55 ft.lbf)
Bolt B: 18 N.m (180 kgf.cm, 13 ft.lbf)
4. DISCONNECT CRANKSHAFT POSITION SENSOR CONNECTOR
5. REMOVE CRANKSHAFT POSITION SENSOR
(a) Remove the 2 bolts and crankshaft position sensor.
Torque: 8.5 N.m (85 kgf.cm, 74 in.lbf)
(b) Remove the O-ring.
HINT
-
At the time assembly, please refer to the following items.
-
Install the crankshaft position sensor with a new gasket.
-
Always a new O-ring when installing the crankshaft position sensor.
INSTALLATION
Installation Is in the reverse order of removal.
