T100 Regular Cab Pickup 2WD V6-3.4L (5VZ-FE) (1997)
/Page-1547001.png)
Brake Master Cylinder: Adjustments
Set SST On Gasket
1. Install a new gasket on the master cylinder.
2. Set the Special Service Tool (SST) # 09737-00010 on the gasket, and lower the pin until its tip slightly touches the piston.
3. Turn the SST upside down, and set it on the booster.
4. Measure the clearance between the booster push rod and pin head (SST). Clearance: 0 mm (0 inch)
Install Master Cylinder
5. Adjust the booster push rod length until the push rod lightly touches the pin head.
