T100 SR5 Extra Cab Pickup 4WD V6-3.4L (5VZ-FE) (1998)
/Page-410002.png)
c. Align the installation mark on the timing belt with the drilled mark of the crankshaft timing pulley.
d. Install the timing belt on the crankshaft timing pulley, No.1 idler and water pump pulleys.
4. INSTALL TIMING BELT GUIDE
Install the guide, facing the cup side outward.
5. INSTALL NO.1 TIMING BELT COVER AND STARTER WIRE BRACKET
a. Check that the timing belt cover gaskets have cracks or peeling, etc.
If the gasket does have cracks or peeling, etc., replace it using following steps, peeling, etc., replace them using following steps.
-
Using a screwdriver and gasket scraper, remove all the old gasket material.
-
Thoroughly clean all components to remove all the loose material.
-
Remove the backing paper from a new gasket and install the gasket evenly to the part of the belt cover shaded back in the illustration.
b. Install the timing belt cover with the 4 bolts.
Torque: 9 Nm (80 inch lbs.)
c. Install the starter wire bracket with the 2 bolts.
6. INSTALL CRANKSHAFT PULLEY
a. Align the pulley set key with the key groove of the pulley, and slide the pulley.
