Tacoma 2WD L4-2.4L (2RZ-FE) (1996)
c.
Measure the voltage between terminals TSL (+) and CLTE (-) of the connector under the following conditions:
^
Cover the sensor with a cloth to avoid direct light.
^
Expose the sensor to light from a distance of 300 mm (11.81 in.) or less with an inspection light.
HINT:
^
If the light is weak, the sensor may not react. Be sure to use an incandescent light for an inspection light.
^
Do not disconnect the solar sensor connector.
Standard:
Procedure D:
a.
Turn the ignition switch ON.
b.
Using the tester, measure the voltage between terminals TSD (+) and CLTE (-) of the connector under the following conditions:
^
Cover the sensor with a cloth to avoid direct light.
^
Expose the sensor to light from a distance of 300 mm (11.81 in.) or less with an inspection light.
HINT:
^
If the light is weak, the sensor may not react. Be sure to use an incandescent light for an inspection light.