Removal and Installation of Tacoma 2WD L4-24L Distributor
/Page-204003.png)
-
Apply seal packing to the ignition coil installing surface of the housing as shown in the illustration.
Seal packing:
Part No. 08826-00080 or equivalent
-
Install the ignition coil with the 4 screws.
-
Connect the 3 wires to the ignition coil terminals with the 2 nuts as shown in the illustration.
NOTICE:
-
When connecting the wires to the ignition coil, insert the wire properly into the groove found on the side of the ignition coil.
-
Be sure the wires do not contact with signal rotor or distributor housing.
4. INSTALL IGNITION COIL DUST COVER.
-
Install a new dust proof packing to the distributor packing.
-
Install the dust cover.
5. INSTALL ROTOR.
