Tacoma 2WD L4-2.4L (2RZ-FE) (1996)
Engine RPM Sensor (NE signal): Service and Repair
REMOVAL
1. REMOVE ENGINE UNDER COVER.
2. REMOVE GENERATOR.
3. REMOVE GENERATOR BRACKET.
-
Remove the 3 bolts and bracket.
Torque:
Bolt A: 74.5 Nm (55 ft lb)
Bolt B: 18 Nm (13 ft lb)
4. DISCONNECT CRANKSHAFT POSITION SENSOR CONNECTOR.
5. REMOVE CRANKSHAFT POSITION SENSOR.
-
Remove the 2 bolts and crankshaft position sensor.
Torque: 8.5 Nm (74 in lb)
-
Remove the O-ring.
CRANK SHAFT POSITION SENSOR INSTALLATION
INSTALLATION HINT: Installation is in the reverse order of removal.