Tacoma 2WD L4-2.4L (2RZ-FE) (1996)
/Page-1303015.png)
d. Using SST 09616-00010, turn the control valve shaft right and left 1 or 2 times.
e. Using a 24 mm hexagon wrench, loosen the cap until the rack guide spring is not functioning.
f.
Using SST 09616-00010 and a torque wrench, tighten the cap until the preload is within specification.
Preload (turning): 0.5 - 1.6 Nm (4.3 - 14.3 inch lbs.)
12. Install rack guide spring cap lock nut.
a. Apply sealant Part No.08833-00080, THREE BOND 1344, LOCTITE 242 or equivalent, to 2 or 3 threads of the nut.
b. Using a 24 mm hexagon wrench to hold the rack guide spring cap and using SST 09922-10010, torque the nut.
Torque to 50 Nm (37 ft. lbs.)
NOTICE: Use SST 09922-10010 in the direction shown in the illustration.
HINT: Use a torque wrench with a fulcrum length of 345 mm(13.58 inch).
c. Recheck the total preload.
Preload (turning): 0.5 - 1.6 Nm (4.3 - 14.3 inch lbs.)
d. Remove the RH and LH rack ends.
13. Install rack housing No. 2 bracket and grommet.
a. Align the matchmarks on the bracket and rack housing.
b. Torque the bolt.
Torque to 39 Nm (29 ft. lbs.)
14. Install RH and LH claw washers and rack ends.
a. Install a new washer, and temporarily tighten the rack end.
