Tacoma 2WD L4-2.7L (2TR-FE) (2005)
9. REMOVE QUARTER TRIM PANEL LOWER LH
10. REMOVE QUARTER INSIDE TRIM BOARD LH
11. REMOVE REAR SEAT 3 POINT TYPE BELT ASSEMBLY OUTER
12. REMOVE AIR BAG SENSOR REAR LH
a. Disconnect the connector from the airbag sensor rear.
b. Remove the nut and the airbag sensor rear.
13. INSPECT AIR BAG SENSOR REAR LH
14. INSTALL AIR BAG SENSOR REAR LH
a. Check that the ignition switch is OFF.
b. Check that the cable is disconnected from the battery negative (-) terminal.
CAUTION: After disconnecting the cable from the terminal, wait for at least 90 seconds before starting the operation.
c. Install the airbag sensor rear LH with the nut.
Torque: 9.0 N.m (92 kgf.cm, 80 in.lbf)
NOTE:
-
Installation of the connector is done with the sensor assembly installed. Make sure the sensor assembly is installed to the specified torque.
-
If the sensor assembly has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor
assembly with a new one.
-
When installing the sensor assembly, make sure that the SRS wiring does not interfere with any other parts and is not pinched between
other parts.
-
After installation, shake the sensor assembly to check that it is not loose.
15. INSTALL REAR SEAT 3 POINT TYPE BELT ASSEMBLY OUTER
16. INSTALL QUARTER INSIDE TRIM BOARD LH
17. INSTALL QUARTER TRIM PANEL LOWER LH
18. INSTALL LUGGAGE COMPARTMENT SIDE TRAY
19. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH
20. INSTALL REAR DOOR SCUFF PLATE LH
21. INSTALL REAR SEAT BACK HINGE SUB-ASSEMBLY LH
22. INSTALL REAR SEAT BACK ASSEMBLY LH
23. INSTALL REAR SEAT BACK HINGE COVER
24. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N.m (40 kgf.cm, 35 in.lbf)
25. INSPECT SRS WARNING LIGHT