Tacoma 2WD L4-2.7L (2TR-FE) (2005)
e. Provisionally install the center support bearing No.1 with the 2 mounting bolts.
HINT: Make sure the bearing is installed with the drain hole facing downwards.
f.
Adjust the center support bearing No.1.
HINT:
^
With the vehicle unladen, adjust the center support bearing No.1 to keep the intervals, as shown.
^
In the same condition, check the center line in the axial direction. Adjust the bearing if necessary.
^
The center bearing center line and center bearing housing center line must be adjusted to within 0 - 1.0 mm (0 - 0.039 inch) of each other
in the vehicle's longitudinal direction when the vehicle is unladen.
g. Torque the 2 bolts.
Torque: 36 Nm (369 kgf-cm, 27 ft. lbs.)
13. CHECK FOR TRANSMISSION OIL LEAKAGE