Tacoma 2WD V6-3.4L (5VZ-FE) (1995)
^
Expose the sensor to light from a distance of 300 mm (11.81 in.) or less with an inspection light.
NOTE:
When using an analog tester, connect the positive (+) lead to terminal 3 and negative (-) lead to terminal 2 of the solar sensor.
HINT:
If the light is weak, the sensor may not react. Be sure to use an incandescent light for an inspection light.
Standard:
Procedure C:
a.
Turn the ignition switch ON.
b.
Measure the voltage between terminals TSR (+) and CLTE (-) of the connector under the following conditions:
^
Cover the sensor with a cloth to avoid direct light.
^
Expose the sensor to light from a distance of 300 mm (11.81 in.) or less with an inspection light.
HINT:
^
If the light is weak, the sensor may not react. Be sure to use an incandescent light for an inspection light.
^
Do not disconnect the solar sensor connector.
Standard: