Tacoma 2WD V6-3.4L (5VZ-FE) (1995)
/Page-1101002.png)
Maximum shaft runout: 2.0 mm (0.079 inch)
Maximum flange runout: 0.1 mm (0.004 inch)
5. Remove outer oil seal. Using SST 09308-00010, remove the oil seal.
6. Replace rear axle bearing.
a. Using SST 09223-56010, 09950-60010 (09951-00560), remove the bearing.
b. Using SST 09515-30010, 09950-60020 (09951-00890), install a new bearing.
7. Install new outer oil seal.
a. Using SST 09950-60010 (09951-00610), 09950-70010 (09951-07150), install a new oil seal.
b. install 4 nuts to the serration bolts.
c. Using a hammer, remove the serration bolts and remove the bearing case.
d. Position the backing plate on a new bearing case and, using 2 socket wrenches, install the serration bolts. Install a new bearing and oil seal
(outer side).
8. Replace bearing case.
a. Remove the oil seal (outer side) and bearing.
b. Install 4 nuts to the serration bolts.
c. using a hammer, remove the serration bolts and the bearing case.
