Tacoma 4WD L4-164.4 2693cc 2.7L DOHC (3RZ-FE) (1996)
/Page-1497009.png)
^
Expose the sensor to light from a distance of 300 mm (11.81 in.) or less with an inspection light.
NOTE:
When using an analog tester, connect the positive (+) lead to terminal 3 and negative (-) lead to terminal 2 of the solar sensor.
HINT:
If the light is weak, the sensor may not react. Be sure to use an incandescent light for an inspection light.
Standard:
Procedure C:
a.
Turn the ignition switch ON.
b.
Measure the voltage between terminals TSR (+) and CLTE (-) of the connector under the following conditions:
^
Cover the sensor with a cloth to avoid direct light.
^
Expose the sensor to light from a distance of 300 mm (11.81 in.) or less with an inspection light.
HINT:
^
If the light is weak, the sensor may not react. Be sure to use an incandescent light for an inspection light.
^
Do not disconnect the solar sensor connector.
Standard:
