Tacoma 4WD L4-164.4 2693cc 2.7L DOHC (3RZ-FE) (1996)
Knock Sensor: Testing and Inspection
1. REMOVE STARTER.
2. REMOVE FUEL FILTER SET BOLTS.
3. REMOVE KNOCK SENSOR.
-
Disconnect the knock sensor connector.
-
Using SST 09816-30010 or equivalent, remove the knock sensor.
4. INSPECT KNOCK SENSOR.
-
Using an ohmmeter, check that there is no continuity between the terminal and body.
-
If there is continuity, replace the sensor.
5. REINSTALL KNOCK SENSOR.
-
Using SST, install the knock sensor.
SST
Torque: 44 N.m (450 kgf.cm, 33 ft.lbf)
-
Connect the knock sensor connector.
6. REINSTALL FUEL FILTER SET BOLTS.
Torque: 20 N.m (200 kgf.cm, 14 ft.lbf)
7. REINSTALL STARTER.