Tacoma 4WD L4-164.4 2693cc 2.7L DOHC (3RZ-FE) (1996)
11. Install RH and LH claw washers and rack ends.
a. Install a new washer, and temporarily tighten the rack end.
HINT: Align the claws of the washer with the steering rack grooves.
b. Using a spanner to hold the steering rack steady, and using SST 09922-10010, torque the rack end.
Torque to 61 Nm (45 ft. lbs.)
NOTICE: Use SST 09922-10010 in the direction shown in the illustration.
HINT: Use a torque wrench with a fulcrum length of 345 mm (13.58 inch).
c. Using a brass bar and hammer, stake the washer.
NOTICE: Avoid any impact to the rack.
12. Install RH and LH rack boots, clamps and clips.
a. Install the rack boot.
NOTICE: Be careful not to damage or twist the boot.
b. Tighten a new clamp, as shown in the illustration.
13. Install RH and LH tie rod ends and lock nuts.