Tacoma 4WD L4-164.4 2693cc 2.7L DOHC (3RZ-FE) (1996)
3.
Remove tool covers under rear jump seats to access # 3 cab mounting bolts.
4.
Remove locking nuts from # 2 and # 3 cab mounting bolts using 14 mm socket.
Note:
This procedure does not require loosening or removal of No.1 cab mount components.
5.
Remove # 2 and # 3 cab mounting bolts.
6.
With vehicle on ground, use hoist to lift left & right rear corners of cab (supporting at pinch welds) above chassis a maximum of 2". This allows
access to two bolts attaching # 3 cab mounts to frame brackets.
7.
Remove frame bracket bolts for # 3 cab mounts.
8.
Remove original # 3 cab mounts and install countermeasure parts. Reinstall frame bracket bolts. Torque bolts to 46 ft.-lbs.
9.
Lower cab to original position and reinstall # 2 & # 3 cab mounting bolts.
10.
Install new locking nuts on # 2 & # 3 cab mounting bolts. Torque nuts to 35 ft.-lbs.
Note:
Locking nuts are non-reusable parts and must be replaced with new parts.
11.
Restore carpet to original position and reinstall kick panels & scuff plates.