Tacoma 4WD L4-164.4 2693cc 2.7L DOHC (3RZ-FE) (1996)
/Page-1169006.png)
9. Replace oil seal (inner side).
a. Using SST 09308-00010, remove the oil seal.
b. Using SST 09950-60020 (09951-00710), 09950-70010 (09951-07150), install a new oil seal.
c. Apply MP grease to the oil seal lip.
10. install rear axle shaft in backing plate.
a. Apply MP grease to the oil seal lip.
b. Install the backing plate and bearing retainer on the rear axle shaft.
c. Using SST and a press, install the rear axle shaft into the backing plate.
d. Using snap ring pliers, install a new snap ring.
11. w/ ABS: Install ABS speed sensor rotor and bearing retainer (differential side). Using SST 09316-60011 (09316-00051) and a press, install a new
sensor rotor and new bearing retainer to the axle shaft.
Standard length: 122.2 ±1.0 mm (4.811 ±0.039 inch)
Hub Bolt Removal and Installation
