Tacoma 4WD L4-2.7L (3RZ-FE) (2004)
Fuel Pump Relay: Testing and Inspection
EFI Main Relay
INSPECTION
1. REMOVE EFI MAIN RELAY (Marking: EFI)
2. INSPECT EFI MAIN RELAY
a. Inspect the relay continuity.
1. Using an ohmmeter, check that there is continuity between terminals 1 and 2.
If there is no continuity, replace the relay.
2. Check that there is no continuity between terminals 3 and 5.
If there is continuity, replace the relay.
b. Inspect the relay operation.
1. Apply battery positive voltage across terminals 1 and 2.