Tacoma 4WD V6-4.0L (1GR-FE) (2006)
1. INSTALL REAR SPEAKER ASSEMBLY
a. Install the rear speaker assembly with the 3 screws.
b. Connect the connector.
2. INSTALL REAR DOOR INSIDE HANDLE SUBASSEMBLY LH
3. INSTALL REAR DOOR TRIM PANEL ASSEMBLY LH
4. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N.m (40 kgf.cm, 35 in.lbf)
Rear Speaker (For Access Cab)
REMOVAL
HINT:
-
Use the same procedures for the RH and LH sides.
-
The procedures listed below are for the LH side.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE LAP BELT OUTER ANCHOR COVER
3. REMOVE REAR DOOR TRIM BOARD SUBASSEMBLY LH
4. REMOVE REAR ACCESS PANEL WEATHERSTRIP LH
5. REMOVE REAR SPEAKER ASSEMBLY
a. Disconnect the connector.
b. Remove the 3 screws and the rear speaker assembly.
INSTALLATION
1. INSTALL REAR SPEAKER ASSEMBLY