Tacoma 4WD V6-4.0L (1GR-FE) (2006)
/Page-1535001.png)
Front Fender Liner: Technical Service Bulletins
Body - Front Fender Liner Pin Hold Clip Procedure
T-SB-0073-08
May 27, 2008
Front Fender Liner Pin Hold Clip Removal / Installation Procedures
Service Category
Vehicle Exterior
Section
Exterior Panels/Trim
Market
USA
Applicability
Introduction
To prevent damage to the front fender liner the following procedure should be used when removing and installing the front fender liner pin hold clip.
Parts Information
Warranty Information
Removal Procedure
^
Upper and lower pin hold clips are used for 2007-2008 Tundra (w/ Resin Front Bumper)
^
This Procedure is not applicable to 2007-2008 Tundra (w/ Steel Front Bumper) as this type of clip is not used on those vehicles.
