Tacoma 4WD V6-4.0L (1GR-FE) (2006)
a. Engage the 2 clips and install the quarter inside trim board.
b. Tighten the 3 screws.
c. Engage the claw and close the cover.
d. Install the floor anchor of the rear seat belt outer with the bolt.
Torque: 42 N.m (430 kgf.cm, 31 ft.lbf)
NOTE:
-
Make sure that the rear seat outer belt is oriented in the correct direction when installing.
-
Be careful not to place the rear seat outer belt over the convex areas of the floor panel.
13. INSTALL QUARTER INSIDE TRIM BOARD RH
HINT: Follow the same procedures as for the quarter inside trim board LH.
14. INSTALL QUARTER TRIM LOWER PANEL LH