Tacoma 4WD V6-4.0L (1GR-FE) (2006)
c. Insert the stop light switch until the body comes into contact with the cushion.
NOTICE:
^
When inserting the stop light switch, support the pedal from behind so that the pedal is not pushed in.
^
Take care not to depress the pedal during the operation.
d. Make a quarter turn clockwise to install the stop light switch.
NOTICE: The turning torque for installing the stop light switch:
Torque: 1.5 Nm (15 kgf-cm, 13 inch lbs.) or less
HINT: Due to the inverse screw structure, turning the stop light switch clockwise will cause it to become loose and eventually detach from the
adjuster.
e. Connect the stop light switch connector to the stop light switch.
f.
Check the protrusion of the rod.
Protrusion of the rod: 1.5 to 2.5 mm (0.059 to 0.098 inch)