Tacoma 4WD V6-4.0L (1GR-FE) (2006)
10. INSTALL BRAKE ACTUATOR HOSE
a. Using needle-nose pliers, install the brake actuator hose and 2 clips.
11. INSTALL BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY
a. Install the cap.
b. Apply lithium soap base glycol grease to the 3 new grommets.
c. Install the 3 grommets to the master cylinder body.
NOTICE: Be careful of the size of each grommets.
d. Install the master cylinder reservoir.
e. Using a pin punch and hammer, install a new pin onto the master cylinder reservoir.
f.
Install the screw onto the master cylinder reservoir.
Torque: 1.7 Nm (17 kgf-cm, 15 inch lbs.)
12. INSTALL BRAKE ACTUATOR BRACKET NO. 1
a. Install the fluid level warning switch connector.
b. Using a hexagon wrench (5 mm), install the brake actuator bracket No. 1 with the screw.
Torque: 7.8 Nm (80 kgf-cm, 69 inch lbs.)
INSTALLATION