Tacoma 4WD V6-4.0L (1GR-FE) (2006)
Control Assembly: Service and Repair
Removal and Installation
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE AIR CONDITIONING CONTROL ASSEMBLY
a. Using a screwdriver, disengage the 4 clips and remove the air conditioner control assembly.
HINT: Tape up the screwdriver tip before use.
b. Disconnect the 2 connectors.
INSTALLATION
1. INSTALL AIR CONDITIONING CONTROL ASSEMBLY
a. Connect the 2 connectors.
b. Engage the 4 clips and install the air conditioning control assembly.
2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N.m (40 kgf.cm, 35 in.lbf)