Tacoma 4WD V6-4.0L (1GR-FE) (2006)
5.
Start the engine and then push and hold the "E/M" button for about 15 seconds until the "CAL" indication appears on the compass display. (At this
time, the compass display is locked in "N.")
6.
Drive the vehicle in a circle at 5 mph (8 km/h) or less. If there is not enough space to drive in a circle, turn the car around as shown, doing two
three-point turns in succession.
7.
When the "CAL" indication goes off and the compass returns to the normal mode, calibration is completed.
NOTE:
Do NOT perform calibration of the compass in a place where the Earth's magnetic field is subject to interference by artificial magnetic fields
(underground parking, under a steel tower, between buildings, roof parking, near a crossing, near a large vehicle, etc.)
^
During calibration, do NOT operate electric systems (moon roof, power windows, etc.) as they may interfere with the calibration.