Tacoma 4WD V6-4.0L (1GR-FE) (2006)
Parts Information
Repair Procedure
1. Remove the roof console box assembly.
A. Remove the screw under the sunglass holder.
B. Disengage the 2 clips and 3 claws.
C. Disconnect the accessory meter connector and map lamp connector.
2. Remove the digital display.
A. Remove the 3 T1O Torx fasteners holding the digital display into the roof console box assembly.
3. Reinstall the new digital display.
A. Reinstall the 3 T1O Torx fasteners holding the digital display into the roof console box assembly.
4. Reinstall the roof console box assembly (See Figure 1).
A. Connect the accessory meter connector and map lamp connector.
B. Reconnect the 3 claws and 2 clips.
C. Reinstall the single screw behind the sunglass holder.
5. Confirm proper operation of the digital display.
6. Calibrate the compass. Refer to the following Technical Service Bulletins for the initial calibration procedure.