Tacoma 4WD V6-4.0L (1GR-FE) (2006)
/Page-365004.png)
^
The test DTCs will NOT be indicated until the system initialization is complete. After the initialization has been completed successfully, the
test DTCs are indicated.
^
If the test DTCs are NOT indicated after several minutes have elapsed, rotate all the tires (including the spare tire) 900 to 2700 degrees. Wait
for several minutes and then repeat step 6.
NOTE:
^
Do NOT turn the ignition switch "OFF" until step 6 is finished.
^
If the initialization fails, refer to the Repair Manual.
It is possible that different tires (tire pressure warning valve and transmitters) from another vehicle have been fitted and the transmitter IDs do
NOT match.
The following operations can be used instead of step 6: Turn the ignition switch from "OFF" to "ON." Monitor the tire pressure values of all
the wheels (5 wheels) using the Diagnostic Tester. If the tire pressure values cannot be monitored, the initialization has failed. It typically takes
2 to 3 minutes to complete the initialization.
