toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Engine Controls - Intermittent No Start Condition|Page 183 > < Engine Controls - Techstream(R) ECU Re-Flash Procedure|Page 178
Page 1
background image

Engine Control Module: All Technical Service Bulletins
Engine Controls - Intermittent No Start Condition

ENGINE
EG011-07
REVISED

March27, 2007

^ July 10, 2007: The Production Change Information section has been added.

^ May 8, 2007: 2007 model year has been added to Applicable Vehicles. Part numbers and calibration data for 2007 model year have been added to the

Parts Information table and the Calibration Identification Chart. The Diagnostic Tester software references have been updated to the latest version.

Previous versions of this TSB should be discarded.

Introduction

Some 2005 - 2007 model year Tacoma vehicles equipped with a 1GR-FE engine may exhibit an intermittent ~no start" condition. Improvements have
been made to the Engine Control Module/ECM (SAE term: Powertrain Control Module/PCM) calibration to reduce the possibility of this condition
occurring. Please use the following procedure to update the calibration.

Applicable Vehicles

^

2005 - 2007 model year Tacoma vehicles equipped with 1GR-FE engine produced BEFORE the Production Change Effective VIN shown below.

Production Change Information

Warranty Information

This repair is covered under the Toyota Federal Emissions Warranty. This warranty is in effect for 96 months or 80,000 miles, whichever occurs first,
from the vehicle's in-service date.

* Warranty application is limited to correction of a problem based upon a customer's specific complaint.

Engine Controls - Intermittent No Start Condition|Page 183 > < Engine Controls - Techstream(R) ECU Re-Flash Procedure|Page 178