Tacoma 4WD V6-4.0L (1GR-FE) (2006)
d. Using a clip remover, remove the wiring harness clamp.
e. Remove the wiring harness clamp.
f.
Remove the bolt and the front seat inner belt.
INSTALLATION
1. INSTALL FRONT SEAT INNER BELT ASSEMBLY LH
a. Slide the front seat to the most forward position.
b. Install the front seat inner belt with the bolt.
Torque: 42 N.m (430 kgf.cm, 31 ft.lbf)
NOTE: Be careful not to place the front seat inner belt over the convex areas of the floor panel.
c. Install the 2 wiring harness clamps.
d. Connect the 2 connectors.
e. Engage the hook.