Tacoma 4WD V6-4.0L (1GR-FE) (2006)
/Page-1417008.png)
1. Remove the seat track cover.
b. for Separate Seat Type Front Passenger Side:
1. Remove the seat track cover.
c. for Separate Folding Seat Type:
1. Remove the seat track cover.
3. REMOVE FRONT SEAT ASSEMBLY
a. for Separate Seat Type Driver Side:
1. Remove the front seat assembly.
b. for Separate Seat Type Front Passenger Side:
1. Remove the front seat assembly.
c. for Separate Folding Seat Type:
1. Remove the front seat assembly.
4. REMOVE FRONT SEAT INNER BELT ASSEMBLY
a. for Separate Seat Type Driver Side:
1. Using a clip remover, remove the wire harness clamp and 2 connector clamps.
2. Remove the wire harness clamp.
3. Disconnect the seat position sensor connector.
4. Remove the nut and front seat inner belt.
b. for Separate Seat Type Front Passenger Side and Separate Folding Seat Type:
1. Disconnect the seat wire connector.
2. Using a clip remover, remove the connector clamp.
3. Remove the wire harness clamp.
4. Remove the nut and front seat inner belt.
INSTALLATION
CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before
servicing (w/ Front Seat Side Airbag).
1. INSTALL FRONT SEAT INNER BELT ASSEMBLY
