Tacoma 4WD V6-4.0L (1GR-FE) (2006)
/Page-1417046.png)
1. REMOVE REAR SEAT BACK HINGE COVER
HINT: Follow the same procedure as for the opposite side.
a. Using a screwdriver with its tip taped in protective tape, disengage the 3 claws and remove the rear seat back hinge cover.
2. REMOVE REAR SEAT BACK ASSEMBLY
3. REMOVE REAR SEAT BACK HINGE SUB-ASSEMBLY
4. REMOVE REAR DOOR SCUFF PLATE
5. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP
a. Separate the rear door opening trim weatherstrip to the extent which allows the removal of the quarter trim lower panel and quarter inside trim
board.
6. REMOVE LUGGAGE COMPARTMENT SIDE TRAY
7. REMOVE QUARTER TRIM LOWER PANEL
8. REMOVE QUARTER INSIDE TRIM BOARD
a. Remove the bolt and remove the floor anchor of the rear seat outer belt.
