Tacoma 4WD V6-4.0L (1GR-FE) (2006)
Seat Position Sensor: Testing and Inspection
Seat Position Sensor (For Bench Seat Type)
ON-VEHICLE INSPECTION
1. REMOVE SEAT POSITION SENSOR (for Vehicle not Involved in Collision)
a. Perform a diagnostic system check.
2. REMOVE SEAT POSITION SENSOR (for Vehicle Involved in Collision)
a. Perform a diagnostic system check.
b. Even if the airbag was not deployed, perform a visual check for damage to the seat position airbag sensor. If there are any defects as mentioned
below, replace the seat position airbag sensor with a new one:
-
Cracks, dents or chips in the case.
-
Cracks or other damage to the connector.
CAUTION: For removal and installation procedures of the seat position airbag sensor.