Tacoma 4WD V6-4.0L (1GR-FE) (2006)
a. Install the 2 stabilizer bushes onto the stabilizer bar.
HINT: Install the stabilizer bush onto the outer side of the mark on the stabilizer bar.
b. Install the stabilizer bar and 2 stabilizer brackets with the 4 bolts.
Torque: 27 Nm (275 kgf-cm, 20 ft. lbs.)
2. INSTALL REAR STABILIZER LINK ASSEMBLY LH
a. Install the stabilizer link with the 2 nuts.
Torque: 69 Nm (704 kgf-cm, 51 ft. lbs.)
HINT: If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud.
3. INSTALL REAR STABILIZER LINK ASSEMBLY RH
NOTICE: The installation procedure for the RH side is the same as that for the LH side.
4. INSTALL REAR WHEEL
Torque: 113 Nm (1,152 kgf-cm, 83 ft. lbs.)