Tacoma 4WD V6-4.0L (1GR-FE) (2006)
Refer to the Technical Information System (TIS) applicable model and model year Repair Manual:
Alignment Inspection Procedure
An alignment inspection and adjustment is required after the installation of the new rear leaf springs. The NEW alignment specifications are provided
below.
1. Measure vehicle height.
Bounce the vehicle up and down at the corners to stabilize the suspension before inspecting the vehicle height.
Measuring points:
^
A is the ground clearance of front wheel center.
^
B is the ground clearance of adjustment cam bolt center (front side).
^
C is the ground clearance of rear wheel center.
^
D is the ground clearance of rear leaf spring front side bushing center.
NOTE
Before inspecting the wheel alignment, check the vehicle height.