Tacoma 4WD V6-4.0L (1GR-FE) (2006)
c. After the tire is inflated, the valve nut may be loose. Retighten the nut to the specified torque and then check for air leaks with soapy water.
Torque: 4.0 Nm (41 kgf-cm, 35 inch lbs.)
NOTICE: The specified torque only applies the first time washer is used.
d. Set the wheel disc to the mounting machine and install the lower tire bead. Position the main body of the valve sensor in the shaded area shown
in the illustration.
NOTICE: If the valve sensor is positioned outside this area, it generates interference with the tire bead, causing possible damage to the valve
sensor.
e. Install the upper bead.
NOTICE: Make sure that the tire bead and tool do not interfere with the main body of the valve sensor and that the valve sensor is not
interfered with the bead.
2. INSTALL FRONT WHEEL
Torque: 113 Nm (1,152 kgf-cm, 83 ft. lbs.)
3. INSTALL REAR WHEEL
Torque: 113 Nm (1,152 kgf-cm, 83 ft. lbs.)
4. INSTALL SPARE TIRE
5. REGISTER TRANSMITTER ID
6. INSPECT TIRE PRESSURE WARNING SYSTEM
DISPOSAL
HINT: The tire pressure warning valve and transmitter is powered by a lithium battery. When disposing of the tire pressure warning valve and
transmitter, remove the battery and dispose of it correctly.
1. DISPOSE OF TIRE PRESSURE WARNING VALVE AND TRANSMITTER
a. Using a screwdriver, pry off the cover. Remove the back cover.